EO and ETO are abbreviations for ethylene oxide. Compare the listed tapes and chemical indicators by their intended use; select an indicator for the specified EO process rather than by colour or appearance alone.
Sterility Assurance and Monitoring/Indicators for Sterilization/Chemical Indicators for Sterilization/Autoclave Tapes/EO Sterilization/Autoclave Chemical Indicators/ Chemical Indicator Class 1
Ethylene oxide is used in processes for some heat- or moisture-sensitive medical products. Suitability depends on the device, packaging, sterilizer and validated process; it is not a universal compatibility claim for plastics, electronics or assembled devices.
Temperature, humidity, exposure time and EO concentration are process variables to check in the selected equipment and indicator documentation. No cycle values are prescribed here. EO and ETO do not designate two different sterilants or establish whether the gas is pure or a mixture.
Preconditioning, exposure and subsequent aeration have different purposes. The equipment photograph illustrates an EO chamber; it does not establish the performance or validation of a particular load.
02
Photographs and process illustrations
EO sterilization chamber photograph. The image illustrates equipment, not the performance or validation of a specific cycle or load.
EO gas tape: verify the manufacturer’s colour reference, reading conditions, storage and expiry for this reference.
04
Use and interpretation
An EO chemical indicator provides the response defined for that model and intended process. Read its initial colour, reference endpoint and specified reading conditions in the instructions. The red-to-blue response belongs to the product explicitly named that way; it must not be applied to every indicator or tape.
Chemical response alone does not demonstrate sterility, adequate aeration or acceptable EO residues. Use the applicable equipment records, chemical and biological monitoring, validated aeration and residual-control procedures required for the device and process.
A tape used outside a package and an indicator intended for a specified position inside it provide different information. Do not substitute one for another solely because both change colour. Product classification and conformity require model-specific documentation.
05
Dimensions, packaging and handling
Check the reference, batch, expiry, packaging integrity and the indicator’s unused appearance before use. Choose the placement, attachment and reading method specified by the manufacturer and the facility procedure.
Record the indicator reference and lot with the load or process record as required. If the response is missing, incomplete or inconsistent with the specified endpoint, follow the facility investigation and disposition procedure; do not release a load on colour alone.
Storage, protection from unintended exposure and shelf life are product-specific. A previously exposed indicator must not be treated as an unused control. Confirm the single-use status of the selected product in its instructions.
06
Product documents and purchasing
EO handling requires suitable equipment, trained personnel and the applicable ventilation and occupational controls. A chemical indicator is not a workplace gas detector.
For purchasing, distinguish the indicator specification from the sterilizer, gas supply and aeration requirements. Request the relevant instructions and supporting reports for the exact reference and target market; this category page does not certify any model.
MEDIWISH · Process monitoring
Specify the process and product format
Send the product reference, sterilization method, packaging material, required dimensions, quantity and destination market. Ask for the model instructions, colour reference, shelf life, storage conditions and applicable technical documents.